High performance polyethylene support. Thermoplastic (TPR) reinforcement on back and fingertips. Smooth nitrile coating/foam nitrile on palm and fingertips. Embossed inside reinforcement on palm. Kevlar® thread on all the seams.
Support: High performance polyethylene fibre.
Coating: nitrile.
Back reinforcement: TPR.
Cut level D.
USA STANDARDS
-ANSI-ISEA 105:2016 : Hand protection
-Resistance to cutting by sharp objects (from A1 to A9) : A4
REGULATION (EU) 2016/425
-EN420:2003+A1:2009 : General requirements
-Dexterity (from 1 to 5) : 5
-EN388:2016 : Protective gloves against mechanical Risks (Levels obtained on the palm)
-Resistance to abrasion (from 1 to 4) : 4
-Resistance to cutting (from 1 to 5) : X
-Resistance to tear (from 1 to 4) : 4
-Resistance to puncture (1 to 4) : 3
-Resistance to cutting by sharp objects (TDM EN ISO 13997) (from A to F) : D
-Protection against impact in metacarpal area (P) (EN13594:2002 6.8.2) : P
-EN13594:2002 4.1.3/6.8.2. : Impact energy attenuation
Heavy industry.
Construction / Civil engineering.
Oil / Gas.
Second work / craftman.
Services / Logistics.
Wearing.
PERFORATION.
Shock.
CUTTING.
Double nitrile coating for oily work.
1st smooth nitrile coating : impermeable to oils
2nd nitrile foam coating : good adhesion.
Flexible reinforcements.
Increased protection from impacts and pinches.
Reinforcement between the thumb and index finger and on the palm.
Increased protection.
Protection against impact in the metacarpal area. After an energy impact of 5J, the force transmitted to the back of the hand cannot exceed 4 kN.
Available only with header card.
Very good abrasion and cut resistance.
Increased lifespan.
Kevlar® thread stitching.
Increased lifespan.
8 cm cuff with Velcro closure.
Perfect adjustment
Reduced discomfort at the wrist, during prolonged use.
No account yet?
Create an Account
